قفل درب، هوشمند، ضد دزد و سرقت، ايجاد واقعی و کامل امنيت، ايمنی و حفاظت از حرز منزل و محل کار

Adopt the most advanced digital detecting technology in the world and secupro series scanner hand held detector is special for detecting metal and alloy articles concealed in human body.		It is highly safe, widely applicable and highly sensitive with a wide detecting range and a good anti-interference capability.
It is applicable in any places such as factories, mines, banks and luxuries houses where expensive metal articles may get lost easily as well as other specific areas like airports customhouse, Embassies, jails, exhibition halls and wherever carrying the metals are prohibited.		Pin 30-60mm, 64 model handgun 150mm, 6 inch long knife 160mm, Diameter 20mm, Steel Ball 90mm
Highly sensitivity, Simple and convenient to use, no adjustment is required, The detection distance will not be changed when the battery voltage drops from 9V to about 7V., Low power consumption, can work for 40 hours continuously, There is automatic and continues alarm when the battery is used up, Switch on/off audio prompt function, With external rechargeable socket hole, Has audio, Light and vibration handoff switch

"Description"

1. Turn on the power switch, if a click sound is heard, it indicates that the power has been connected, and the green LED will turn on at the same time. If no click sound is heard, it indicates that no battery has been installed or the battery is not well connected. If the click sound is heard one after another, it indicates that the battery can not be used any more and a new battery shall be installed.

2. When the switch-on click sound stops, the highly sensitive detection can be performed. Grasp the handle and detect with the detection face around the object being detected, there will an alarm when a metal object is detected. In the mean time, the green LED will turn into red. When the detection stops, the alarm stops and the red LED turns into green.

Sensitivity Adjustment:

1. The sensitivity shall be adjusted when performance instability is observed or sound is produced when detecting human body without any metal stuff because requirement or the sensitivity is too high.

2. Insert a small straight-shaped screw driver into the small hole of the handle of the detector and rotate clockwise until a sound is heard, then rotate counter-clockwise barely to the position where no sound is produced, then rotate for another half a circle, until the sensitivity meets the requirement.

قبلی

بازگشت به صفحه اصلی